I am trying to use the Pixel Mapper with Artnet output to run some pixel strip. Screenmonkey appears not to be rendering the output.
I think I have the pixel map set up correctly, and the nodes are appearing green (no conflicts). On the artnet settings it shows Universe 0 being sent, and the status is green.
The program monitor shows the pixel map, but doesn't display any output. Under General Settings, should the display profile be set to 'DMX Control' or 'Primary Full Screen'? I've seen occasional bits of output when changing the display profile, but it only works for a short time. Using "the artnetominator" it appears some data is being sent, but only 1 packet every few seconds.
As a test I changed the display renderer back to standard and restarted, and it displays fine on the screen, so I don't think it's anything silly like the faders being down.
Any pointers on where to look? I've had other program generating artnet and displaying on my strings, so I don't think it's a hardware problem.
Thanks,
Alan
I think I have the pixel map set up correctly, and the nodes are appearing green (no conflicts). On the artnet settings it shows Universe 0 being sent, and the status is green.
The program monitor shows the pixel map, but doesn't display any output. Under General Settings, should the display profile be set to 'DMX Control' or 'Primary Full Screen'? I've seen occasional bits of output when changing the display profile, but it only works for a short time. Using "the artnetominator" it appears some data is being sent, but only 1 packet every few seconds.
As a test I changed the display renderer back to standard and restarted, and it displays fine on the screen, so I don't think it's anything silly like the faders being down.
Any pointers on where to look? I've had other program generating artnet and displaying on my strings, so I don't think it's a hardware problem.
Thanks,
Alan